CI-203 Outputting “object too small”

CI-203 Outputting “object too small” on certain measurements due to some potential issues with the process being used The leaf should be scanned only through the “optimal scan area” as shown below. Any parts of the leaf that are not passed through the scan area will not be measured and accuracy is affected. The measurement arm must be fully closed on the leaf to take accurate measurements. (from your video it appears that the measurement arm is barely closed as the leaf is pulled through due to the irregular shape of the leaf). You can use clear binder sleeves (as shown below) cut to appropriate width and placed above and below each leaf to create a flat surface that is much easier to pull through the CI-203.